Description:

The TE406P is the next generation of Digium hardware that offers an on-board echo cancellation module. It supports E1, T1, and J1 environments and is selectable on a per-card or per-port basis.

The echo cancellation module supports all T1, E1, and J1 channels and improves voice quality in environments where software echo cancellation is not sufficient. The TE406P reduces CPU overhead required for software echo cancellation thereby, freeing resources for other processes, such as codec translation. By supporting 16ms with 128 channels or 64ms on 32 channels this card will perform in the most difficult of environments.

Digium has designed the TE406P to be fully compatible with existing software applications and it is fully integrated with the Asterisk Open Source PBX/IVR platform. Also, the open source driver supports an API interface for custom application development. With the combination of Digium Hardware and Asterisk software, numerous combinations of telephony configurations are possible. From the traditional PBX to VoIP Gateways, Digium solutions are paving the way for a new generation of worldwide communications.

The TE406P supports industry standard telephony and data protocols, including Primary Rate ISDN (both N. American and Standard Euro) protocol families for voice, PPP, Cisco, HDLC, and Frame Relay data modes. Both line-side and trunk-side interfaces are supported, also included are advanced call features. The TE406P is for use only with a 5.0 volt PCI slot.

The TE406P is certified for Europe and North America.

Please review the information on this Digium page regarding PCI slots. Before you order, please ensure that the card you are ordering will fit the PCI slot in your computer. There is a 15% restocking fee on returned Digium products, and we cannot take responsibility for incorrect parts ordered.

Back to Top

Features:

• Data Modes:
• Cisco HDLC
• HDLC
• PPP
• Multilink PPP
• Frame Relay


• Voice Modes:
• PRI CPE & PRI NET
• NI1
• NI2
• EuroISDN
• 4ESS (AT&T)
• 5ESS (Lucent)
• DMS100
• E&M
• Wink
• Feature Group B
• Feature Group D
• FXO & FXS
• Ground Start
• Loop Start
• Loop Start with Disconnect Detect


• Certifications:
• Telecom
• FCC Part 68 (TIA-968-A)
• IC CS-03
• TBR 4
• TBR 12
• TBR 13
• AS/ACIF S038
• AS/ACIF S016
• Safety
• UL/CSA 60950
• IEC 60950
• EN60950
• AS/NZS 60950
• Note: Finland, Norway and Sweden require that equipment using this product must be located in a Restricted Access Location (RAL).



Back to Top



Specifications:

None Available.

Back to Top